Three components thixotropic epoxy mortar that creates a waterproofing layer highly resistant to positive and negative hydrostatic pressure.


Reticle on damp substrates
Counter-damp humidity
Applicable on vertical surfaces
Tinted and paintable


The product was specifically developed for interior or exterior applications over cementitious substrates subjected to negative hydrostatic pressure.

WINPOX CEMENT TIXO is the ideal solution for providing excellent vapor barrier to slabs on grade, elevator shafts, concrete floors (including industrial) or other concrete substrates situated above rooms or other places with high moisture content (steam rooms, bathrooms, interior swimming pools, etc.).

Any WINKLER liquid applied products or special mortars can be applied over surfaces treated with WINPOX CEMENT TIXO.


Concrete tanks
Swimming pools
Lift rooms
Industrial flooring
Applicable inside and outside

    array(1) { [0]=> string(1) "1" }
  • Application

    Apply on clean surfaces with spatula. Wet the substrate when dry. Apply with 1 to 3 mm thickness. Mix at low RPM.

  • Consumption

    0.45 Lbs. per Sq. Ft. (2.2 Kg. / m²) every 40 mils (1 mm) of wet film thickness.

  • Useful Advices

    Mix component A with component B until a homogeneous compound is obtained. Finally, add C component slowly until a homogeneous mixture is obtained. Apply product at ambient and substrate temperatures between 41F and 95F (+5°C and +35°C) on dump (superficially wet) surfaces away from the direct sun exposure. Allow the product to cure at temperatures between 41F and 95F (+5°C and +35°C) away from direct sun exposure. Do not apply the product if inclement weather, rain, heavy dew or freezing are forecasted. Sand after 24 hours before applying a new coat or other product. Allow minimum of 48 hours for curing after last coat of WINPOX CEMENT TIXO, before covering with other product.


    Small Kit: 33.95 Lbs. (15.4 Kg) bucket containing: Part A 1.98 Lbs. (0.9 Kg), Part B 5.51 Lbs. (2.5 Kg) and Part C 26.46 Lbs. (12 kg). Large Kit: 67.9 Lbs. (30.8 Kg) bucket containing: Part A 3.97 Lbs. (1.8 Kg), Part B 11.02 Lbs. (5 Kg) and Part C 52.91 Lbs. (24 Kg).


    When kept in its sealed, undamaged package in a shaded covered place at temperatures between 41F and 95F (+5°C and +35°C) product can be stored for 12 months.

  • Technical data sheet
  • Certifications