Water-based adhesive for bituminous membranes and insulating panels, based on bitumen and synthetic polymers. Thanks to its formulation it’s very resistant to water and aging.
It can be applied with roller, brush, making sure to apply an even and constant layer. Seal the joints externally by using a spatula or trowel. Apply on a dry surface, otherwise the drying time can take much longer.
1,15 Gallons /100 sq.ft (0,5 kg/m²) for non-porous support and without alterations (membranes and panels). 1,15 Gallons /100 sq.ft (0,5 kg/m²) for joints sealing. 1,15 – 1,7 Gallons /100 sq.ft (0,5 – 0,75 kg/m²) depending on the porosity and irregularities of supports.
Ideal adhesive for horizontal positions, on surfaces with a slope not exceeding 45° and vertical joints, between 15,7 inch and 19,7 inch (between 40 and 50 cm) high, of bituminous membranes and insulating panels, in cases where torch welding or solvent-base adhesives cannot be used. It can be used even for sealing and joining bituminous membranes. It has an excellent absorbing power, but it is still advisable to full clear the support of: dust, brittle parts and foreign substances. Apply at temperatures between 41°F and 95°F (+5°C and +35°C).
1,2 – 4,9 gallons per pail (5 - 20 kg pails).
The product has 12 months shelf-life if properly packed and stored in a dry and protected place. It is not frost proof. Store and apply between 41°F and 95°F (+5°C and +35°C). Accessori: Winseal.
Technical data sheet